Before you will begin this work, measure car height between a bend of a wing and the earth. Remember the given size and recheck after the work termination. If the difference which cannot be corrected independently turns out, address on service centre Ford.

Removal spend in the following sequence:

- Remove a back wheel;

Fig. 256. Removal of the stabilizer of cross-section stability

- Turn away a nut of fastening of a rack of the stabilizer of cross-section stability to the lever (fig. 256);

- The cross-section lever from below prop up a mobile jack;

- Turn away external bolts, internal while leave on a place;

- Unload a jack and take out a spring;

Fig. 257. Removal of the cross-section lever

- Take out internal bolts and remove the cross-section lever (fig. 257).