Installation spend in the following sequence:

- At installation use only new bolts, nuts and washers;

Fig. 244. Fastening of the cross-section lever: 1, 2 — forward bolts; 3 — the bottom fixing bolt

- Fixing bolts of the cross-section lever tighten as follows: a nut 1 (fig. 244) preliminary tighten the moment 100 Нм, and then tighten on 60 , a nut 2 tighten the moment 120 Нм, a bolt 3 preliminary tighten the moment 120 Нм then tighten on 90 . An inhaling of a bolt 3 check up динамометрическим a key, whether there corresponds the moment of an inhaling 170 230 Нм.

- Do not forget about the heat-shielding screen on the cross-section lever;

Fig. 245. Installation of a spherical support: 1 — a spherical support; 2 — a bolt

- Establish a spherical support 1 (fig. 245) and tighten a bolt 2 moment 50 Нм;

- Establish a forward wheel;

- Finish installation in sequence, return to removal.