Removal spend in the following sequence:

- Raise a back part of the car and reliably establish on support;

- Remove the stabilizer of cross-section stability;

- Fix ступичный knot and disconnect the bottom cross-section lever;

- Remove the top lever;

Fig. 251. Removal of the plug of the stabilizer

- Lower an exhaust pipe in gathering so that the distance to a cross-section beam was sufficient. Remove the plug of the stabilizer of cross-section stability (fig. 251);

- Prop up a cross-section beam by means of a suitable mobile jack;

Fig. 252. Bolts of fastening of a cross-section beam

- Turn away bolts of fastening of a cross-section beam: on three bolts c each party (fig. 252);

- Lower a cross-section beam and put near to the car.