Before the work beginning measure car height between a bend of a wing and the earth. Remember the given size and recheck it after the work termination. If the difference which cannot be corrected independently turns out, address on service centre Ford.

Stabilizer removal spend in the following sequence:

- Disconnect the stabilizer from both cross-section levers;

Fig. 259. Dismantle of the stabilizer of cross-section stability: 1 — a bolt; 2 — tightening скоба; 3 — the stabilizer; 4 — the plug

- Remove two plugs of the stabilizer. For this purpose turn away bolts 1 (fig. 259), remove tightening скобы 2, lift the stabilizer 3 and remove it.