Ford Fokus>> Coupling>> Coupling replacement in a case when on the car the transmission iB5 is established
Before removal of coupling it is necessary for you to remove a transmission. Do it as it is described in section "Transmission".
For performance of works on removal of coupling workshops Ford use the following special tool:
- Aligning оправка 308204 (16-067);
- Clamp of a cranked shaft 303393 (21-168).
Coupling removal spend in the following sequence:
- Turn on cross-wise all fixing bolts of a casing of coupling in gathering. The moment of an inhaling of bolts reduce, gradually turning on them on 2 turns while the spring completely will not unload;
- Remove a casing of coupling with press and conducted by disks from pins;
- Check up a technical condition of details of coupling.
Coupling installation spend in the following sequence:
- Clear rubbing surfaces of a flywheel and a press disk, remove a dust from coupling details, avoid use of cleaners and solvents;

Fig. 216. A centering of a conducted disk



- By means of aligning оправки centre a conducted disk concerning an axis of a cranked shaft (fig. 216);

Fig. 217. Coupling installation: 1 — a bolt; 2 — a coupling casing in gathering; 3 — aligning оправка



- Establish press disks on a flywheel. Bolts 2 tighten in regular intervals cross-wise. Bolts tighten the moment 29 Нм after that take out оправку (fig. 217).