At service stations Ford for semiaxis installation use the special adaptation 304-161 (14-041).

Drive removal spend in the following sequence:

- Brake the car a lay brake;

- Release on 5 turns of a nut of the right rack of shock-absorbers. The piston rod is blocked by means of a key with internal шестигранной a head;

- Release a nut of a nave of a wheel by means of face key SW32, and also nuts of fastening of the right wheel;

- Lift a forward part of the car and reliably fix on support then remove a wheel;

- On the right dismantle the cross-section lever;

- Turn away a nut of fastening of a drive of wheels (the nut can be used only four times, mark a nut);

- Take out полуось from a nave of a wheel by means of a usual stripper. The maximum bend angle in the hinge 18 ;

- Remove a basic coupler of an intermediate shaft — the coupler is applied only once;

- Take out an intermediate shaft together with shaft of a drive from a transmission, thus do not bend the internal hinge more, than on 18 ;

- Close the formed aperture in a transmission a pure rag against oil leak;

- Disconnect a shaft of a drive of wheels from an intermediate shaft (dismantle of an intermediate shaft see).