Before installation replace all самоконтрящиеся nuts on new and put a few greasings on a carving part of a shaft and шлицы.

Installation spend in the following sequence:

- Insert a new drive of wheels with a new lock ring into a transmission. The lock ring at installation should get to a flute. Thus do not damage an epiploon in a transmission. At installation in a transmission iB5 apply the adjusting plug which is delivered complete with new consolidation;

- Insert шлицевый the end of a drive of wheels in шлицевую a part of a nave of a wheel. For this purpose strike a rubber hammer on an outer side of a nave of a wheel or establish a drive of a wheel by means of the special adaptation against the stop in a nave. When the drive of wheels is established without the special adaptation, it is necessary запрессовать it so that from a nave enough of coils of a carving seemed to screw a nut. Further tighten a nut;

- Check up oil level in a transmission and if necessary add;

- Establish the cross-section lever at the left;

- Establish a wheel with a preliminary inhaling of nuts;

- Remove the car from support and establish on wheels;

- Tighten a nut of fastening of a drive of wheels the moment 316 Нм. Thus ask the assistant to press a brake pedal;

- Definitively tighten wheel nuts;

- Tighten a nut of a rack of the shock-absorber the moment 48 Нм;

- Make a trial trip then check up an inhaling of carving connections, whether ослабли they.