Installation spend in the following sequence:

Fig. 322. Fastening of a keeping arm (the engine 1.8/2.0)

- Turn away bolts of fastening of a back keeping arm (fig. 322). For this purpose the holder with a keeping arm slightly shift, adjusting surfaces should adjoin.

The prevention Otherwise it can lead to damage of the holder and later to failure каталитического neutralizer.

- Establish каталитический neutralizer with new nuts and linings, a nut at first acquire;

- Connect сильфон with каталитическим neutralizer (apply new linings);

- Lower the car;

- Tighten all nuts;

- Establish the gauge of a ljambda-probe with new consolidation;

- Attach a contact socket to the gauge a ljambda-probe;

- Establish the heat-shielding screen;

- Establish the pipeline;

- Lift the car and fix on supports;

Fig. 323. Pipe fastening (the engine 1.8/2.0)

- Wrap nuts (fig. 323);

- Forward keeping arm fix, having wrapped bolts the moment 22 Нм;

Fig. 324. Fastening bolts (the engine 1.8/2.0)

- Bolts wrap the moment 47 Нм (fig. 324);

- Establish the bottom holder. Wrap nuts the moment 4 Нм and bolts the moment 22 Нм;

- Establish the heat-shielding screen;

- Lower the car and make a trial trip. If necessary tighten carving connections.