Installation of the power unit spend in the following sequence:

- Connect a contact socket of the gauge of speed of the car (VSS);

- Connect a contact socket of the switch of light of a backing;

- Lift the car so that under it it was possible to bring an assembly table with the power unit;

- Cautiously lower the car;

- Establish forward and back support of the power unit;

- Lift the car so that from under it it was possible to deduce an assembly table;

- Attach a tube to the working cylinder of coupling;

- Establish both semiaxes, thus do not turn SHRUS on the big corners. Скобу the intermediate bearing and a fastening nut replace with the new.

Models with the conditioner

Collect an arm of the pump of the hydraulic booster of a steering together with натяжителем a belt of a drive of auxiliary units.

All models

Connect a spherical support of both cross-section levers of a suspension bracket to a fist;

- Connect cables of the mechanism of management of a transmission;

- Connect contact sockets of the oxygen gauge and the gauge of an angle of rotation of a cranked shaft;

- Connect a contact socket of the gauge of pressure of oil;

- Establish a reception pipe with сильфоном, a lining replace with the new;

- Establish a starter.

Models without the conditioner

Establish the pump of the hydraulic booster of a steering together with a basic plate;

- Connect the pipeline of the hydraulic booster of a steering.

Models with the conditioner

Establish the conditioner compressor;

- Establish an arm of the pipeline of a high pressure of the hydraulic booster of a steering.

All models

Establish a belt of a drive of auxiliary units, pull it and put a cover;

- Lower the car;

- Establish hoses of system of cooling. Pay attention to collars, they should be established without warps;

- Connect the vacuum pipeline to the case with the activated coal.

Models without the conditioner

Connect wires to the generator;

- Connect a contact socket of the hydraulic booster of a steering.

Models with the conditioner

Connect wires to the generator.

All models

Connect the remained pipelines and hoses;

- Connect the central contact socket of a plait of wires of the engine and the gauge of an angle of rotation of a camshaft (СМР);

- Connect cables of the mechanism of management of a transmission;

- Establish a heat-shielding casing of a final collector and a wire of connection with "weight";

- Connect fuel tubes;

- Establish a cable of an accelerator and fix it;

- Establish the air filter with a sleeve of a fence of air;

- Connect a contact socket to the gauge of the mass expense of air;

- Attach a ventilation hose картера to a block head;

- Establish a broad tank of system of cooling;

- Fix on clips a tank of a liquid of the hydraulic booster of a steering;

- Tighten nuts of rods of the right and left shock-absorbers;

- Establish an arm of the storage battery and the battery;

- Pour in a broad tank cooling liquid;

- Remove air from hydraulic system of coupling;

- Check up oil level in the engine;

- Connect wires to plugs of the storage battery;

- Start up the engine and warm up it. Check up tightness of all connections and hoses;

- Make a trial trip run not less than 20 km. In this time electronic control systems of the engine and the car should be activated. If you find out failures in engine work, for example non-uniformity of rotation of a cranked shaft of the engine idling, поезжайте on specialised station Ford where to you will reprogram the management block anew;

- After a trial trip again check up levels of working liquids, reliability of fixing connections and tightness шланговых.